A Bersa Model 226DA with factory walnut grip stocks. The left side of the Bersa Model 224DA slide bears the rollmark: "BERSA S.A. RAMOS MEJIA, ARGENTINA" and below that, " MOD. 226 DA CAL. .22 L.R.".  The  serial number is located on the left side of the frame, above the trigger, with the legend "INDUSTRIA AGENTINA" immediately below.

_____________________________________________________________
Sights :

.	Rear	- windage-adjustable, notched blade, dovetailed into slide
.	Front	- attached to barrel via bushing

Controls : (images are of the similar 224 DA)



Parts Diagram :

1. Slide 2. Rear Sight 3. Rear Sight Blade 4. Rear Sight Spring 5. Rear Sight Screw 6. Front Sight 7. Extractor 8. Extractor Spring 9. Extractor Pin 10. Firing Pin 11. Firing Pin Spring 12. Safety 13. Safety Stop 14. Safety Spring 15. Slide Catch 16. Slide Catch Spring 17. Barrel 18. Front Sight Nut 19. Recoil Spring 20. Frame 21. Ejector Pin 22. Hammer Pin 23. Cocking Piece Pin 24. Barrel Pin 25. Grip Pin 26. Ejector

27. Ejector Bushing 28. Disassembly Lever 29. Slide Stop 30. Slide Stop Spring 31. Magazine 32. Magazine Feeder Platform (follower) 33. Magazine Spring 34. Magazine Bottom 35. Magazine Bottom Holder 36. Magazine Catch 37. Magazine Catch Spring 38. Magazine Catch Screw 39. Magazine Safety 40. Magazine Safety Spring 41. Trigger 42. Trigger Spring 43. Disconnector (trigger bar) 44. Disconnector Spring 45. Hammer 46. Cocking Piece 47. Hammer Spring Guide 48. Hammer Spring 49. Hammer Release 50. Right Grip Panel 51. Left Grip panel 52. Grip Screw

_______________________________________________________

The Model 226DA was the double-action successor to the single-action Model 226, retaining the latter's 'combat' trigger guard (providing a forward finger rest), and the swing-down disassembly lever on the right side of the frame, but adopting a new tang trigger and a different disconnector bar. 
The earlier trigger safety is discarded, and the magazine catch moved to the vacated location. 
The magazine disconnect safety is retained, and the slide-mounted hammer safety of the second-generation pistols is reinstated.

Disassembly begins with switching down the disassembly lever to allow a full rearward pull on the slide against recoil spring pressure, until the slide leaves frame-rail engagement. The rear of the slide is then lifted slightly up and off the frame and frame-rails, and allowed to return forward, until fully off the the frame and the barrel. Removal of the slide catch and driving out other pins permits further and further disassembly.

The Model 226DA was in production only from 1986 to 1988, after which Bersa's fifth generation of pistols was launched and the Model 26 claimed its turn as Bersa's 6-inch barreled .22 LR pistol.

--->=o=<---

© 2005 Horge 
All images and content are the property of the webmaster or contributing authors and photographers
and may not be used without owners' written consent.